iClaims Intelligence

1001 CUSTOMER REQUESTED. The roof needs a complete re-seal. Two hours and 10-12 tubes of dicor. The reseal took more tubes of dicor than I initially thought. I cleaned and re sealed the entire roof. During the re seal, I noticed a few small punctures in the membrane on the ds front corner. The decking isn't soft or have any signs of water damage. I took pictures and sealed it with eturnabon tape.

needs-review • confidence 0.34

broken plastic step trim

needs-review • confidence 0.27

remove the broken trim below the entry steps cleaned surface install new trim and silicone edges

needs-review • confidence 0.27

1001 CUSTOMER REQUESTED. The roof needs a complete re-seal. Two hours and 10-12 tubes of dicor. The reseal took more tubes of dicor than I initially thought. I cleaned and re sealed the entire roof. During the re seal, I noticed a few small punctures in the membrane on the ds front corner. The decking isn't soft or have any signs of water damage. I took pictures and sealed it with eturnabon tape.

needs-review • confidence 0.25

CUSTOMER STATES THAT THE REFER SLIDE OUT W 1020 GRAND DOES NOT GO OUT PROPERLY- CUSTOMER STATES THAT THEY HAVE TO PUSH THE SLIDE OUT ON THE REFER END IN ORDER TO GET IT TO GO OUT- WOULD LIKE TO HAVE DIAGNOSED- CUSTOMER STATES THAT THEY IS SOME EVIDENCE OF WEAR ON THE S/O RAILS- CUSTOMER STATES THAT THERE ARE SIGNS OF DAMAGE ON THE OPPOSITE SIDE OF THE SLIDE TOP- SCHWINTEK SYSTEM WAS REPLACED PREVIOUSLY-

needs-review • confidence 0.22

pics taken the racks on slide out are chewed and popping really bad will need a new swyteck The schwintek wasn't installed properly. I overrode the system, ran it almost the way out, took the first few screws out of the racks, and ran the slide out all the way. I Continued on page 2 PAGE 2 Work Order : 9805B ****************************************************************************** Job # Description JOB INFORMATION Type Bill To ****************************************************************************** braced the floor with slide jacks, cut the sealant ,removed all the screws and a lot of them sheared off. I got the racks and columns out, removed the broken screws, cleaned the sealant off the side of the unit, puttied and timed the new shwintek system. The sqaured up the slide in the hole, pound spacer blocks on one side and attached one side of he schwintek. I pulled the blocks out, put the other side in, and secured everything with new screws. I ran the slide out in, attached everything on the inside, and ran the slide in and out to test it. I siliconed along the top of the racks and the whole length of the columns.

needs-review • confidence 0.22