iClaims Intelligence

traced down under the unit in the underbelly the leak i then noticed it was coming from Sublet Repairs: 0.00 above the tank i then found under the sink the check vlave had bugs init and was leaking badly i cleaned out the bugs and put a screen over the top of the vlave and then i had to cove r the access holes in the underbelly and sealed them with silicone. Remedy: traced down under the unit in the underbelly the leak i then noticed it was coming from above the tank i then found under the sink the check vlave had bugs init and was leaking badly i cleaned out the bugs and put a screen over the top of the vlave and then i had to cove r the access holes in the underbelly and sealed them with silicone. Part Return Req: Yes Status: Approved Operation Line 3 Flat Rate Code: 22718 UNDERBELLY - REPAIR Fault Code: GOODWILL DEALER Serial #: Model #: Notes: 11/24 bh added more photos approved 2 hrs for line 3 10/31/2025 Paul- There are no images attached. at .2. I will good will for dealer 11-10 PHOTOS ADDED Problem: UNDERBELLY WAS FILLED WITH WATER WHEN CUSTOMER DROVE AWAY FROM Time Requested: 2.1 THERE LOCATION THE CAMPER HAD BEEN FOR OVER A WEEK. INSPECT WHERE WATER Time Allowed: 1 MAY HAVE ENTERED THE UNDERBELLY AND VERIFY UNDERBELLY IS OK Sublet Repairs: 0.00

gap • confidence 0.95

FAILED TO BUILD IT CORRCTLY when running the slide room in and out the floor bows Sublet Repairs: 0.00 and tore the wall apart Remedy: REMOVED THE RECLINERS AND TOOK APART THE DINETTE BOOTH I MEASURE AND CUT OUTTHE LOWER BOARD AND DRILLED HOLES INTHE NEW BOARD FOR THE WIRES AND AND DRILLED HOLES FOR THE NEW SCREWS AND RESCESSED THE MOUNTING HOLES . I THEN INSTALLED AND MADE SURE THE SCREWS DID NOT GO THROUGH THE FLOOR. I THEN MEASURED FOR THE CROSS BRACES AND DRILLED POCKET HOLES FOR THE SCREWS AND INSTALLED WITH LIQUID NAILS AND SCREWS I CUT AND IINSTALLED 3 BRACES I ALSO INSTALLED METAL L BRACKETS TO HELP HOLLD TOGETHER. THEN I INSTALLED THE DECORE END PEICE AND INSTALLED SCREWS I LIQUID NAILED IT ALSO AND INSTALLED EXTRA SCREWS . I HAD TO TAKE THE SEAT APART AND THE WIRNG TO GET THE NEW PANEL INSTALLED ON THE INSIDE OF THE BOOTH ONSCE INSTALLED I THEN REINSTALLED THE WIRING I INSTALLED NEW PANELING AND NEW TRIM AROUND THE PANELING AND FLLED ALL THE HOLES WITH PUTTY AND REINSTALLED THE RECLINERS AND AD RAN ROOM IN AND OUT SEVERAL TIMES TO MAKE SUR EVERYTHING HELD PUTTY AND THEN REINSTALLED THE RECLINERS. Part Return Req: No Status: Approved with Modifications Operation Line 2 Flat Rate Code: 22488 FRESH WATER - VACUUM BREAKER - Fault Code: VENDOR REPLACE (Part Return Required) Serial #: Model #: Notes: Problem: WHEN THE BLACK TANK FLUSH IS BEING USED IT LEAKS WATER AND SOME Time Requested: .75 WATER HAS GONE TO THE UNDER BELLY Time Allowed: .75

gap • confidence 0.81

.removed and inspected and found no issues and put back together. Remedy: .removed and inspected and found no issues and put back together. Part Return Req: No Status: Approved with Modifications Operation Line 4 Flat Rate Code: 22688 SCISSOR JACK - REPLACE (Photos Required) Fault Code: VENDOR (Photo of tag required) Serial #: Model #: Notes: Problem: REAR LEFT STABILIZER IS BENT Time Requested: .5

gap • confidence 0.75