iClaims Intelligence

MYRV 12024 • Paid • open-range

No evidence summary yet.

Path: /home/openclaw/nas/Dropbox/MYRV 12024/8- Claims Paid/August 2026/Open Range/73840/Paid claim.pdf

I removed the access panel at the bottom of the shower and noticed the P-trap was in two pieces. I dont have access to the backside of the P-trap to remove from the shower drain. I removed all the screws out of the two end pieces, two corner pieces, and the three pieces of trim that cover the top lip of the shower surround. I pulled the shower surround up and removed the P-trap and noticed that the glue joint was barely glued together to begin with. I cleaned off all the excess glue reassembled it glued in place with ABS glue. Put the P-trap back on the bottom of the shower pan and tried to reinstall it, and thats when I see the reason why it was barely glued is because its 3/4 of an inch too tall now. I had to cut the glued pieces back apart and using my PVC drill drill out the pieces of glued in pipe from the fittings get another piece of ABS and cut the length. I dry fit everything together make sure everything would fit. When Page 1 of 2 © 2026 Integrated Dealer Systems *73840* everything fit properly, the angle of the drain that goes through the floor wasnt gonna fit. I had to cut that Promised Date: 11 AUG 26 W/O: 73840 pipe, fit everything together and using a rubber coupler repair the pipe that goes down through the floor. I had to scrape all the silicone off of the trim that covers the shower pan, reinstall all of those along with the corner trims and end pieces. I ran the water for five minutes down the P-trap. No leaks were noticed. Resealed the shower pan, and reinstall the access plate. 3.00HRS

matched • confidence 0.98

I removed the two burners, the two knobs and the stove, top cover, repositioned the thermocouples to allow flame to be seen while theres a pan on the burner. This stove does not have igniters, so it will not ignite on its own by design. I had to remove the entire stove assembly in order to get the model serial number that is on the bottom of the stove pan. I reinstalled the stove reinstalled the top reinstalled the burners and the knobs. Filled a pan with water. And set on both burners one at a time to test *60942* function. Stove top now works as designed. Job completed. .50HRS

matched • confidence 0.87

The thermal couple on both burners is right up against the burner and will not allow the flame to be seen when there is a pot or a pan on the burner.

matched • confidence 0.67