iClaims Intelligence

Found during the SFD the spin well not for the bottom tank drain was cracked at the base and leaking Disconnected all four wires for the tank sensors disconnected the drain waterline disconnected the waterline for the water pump disconnected the gravity fill line disconnected the one strap on the far right side of the unit or entry door side remove four screws from the angle iron that would be the width ways tank support slid the tank support out of the way brought the tank down tank is to be sent off for repair job will be on hold until the tank returns Tank returned from repair took the tank out to the unit pushed it underneath the unit began realigning all the components and pushing the tank up into place Connected the gravity fill and the overflow line this was done with hose clamps once the tank was up in in place gravity fill and overflow were connected. Pull the angle iron back in place that supports the tank on either side reattached it with four screws to the frame two screws on each side. Put the elbow back in the bottom of the tank for the water pump reconnected the line with a current sitting But the plug in the bottom of the tank for drainage Reconnected the tank sensors all four wires tightened them Move the tank strap from the entry door side to the center where the drain and the water pump pick up liner Page 1 of 3 © 2026 Integrated Dealer Systems *73744* app tightened it so that it would support the tank in the metal and prevent Boeing and fracturing fittings in Promised Date: 21 JUL 26 W/O: 73744 the future Fill the tank approximately half full check for leaks on the gravity fill check for leaks on the pump line and on the drain plug no leaks detected tank is installed. It is working correctly. The job is now complete.

partial-match • confidence 0.37