iClaims Intelligence

MYRV 12024 • Paid • open-range

No evidence summary yet.

Path: /home/openclaw/nas/Dropbox/MYRV 12024/8- Claims Paid/September 2026/Open range/73528/Paid claim.pdf

Tape on wall needs to be removed. The wall ends need to be stapled and add battens to *60349* match the color of the wall. Battens need to be stapled over the center of the split walls. Battens have to be cut into size in order to fit. Need to order two 8 ft sticks Photos attached Request 1.5 06.16.26: Found the wall to the right of the entry by the bedroom, under the bedroom window had come completely loose at both seams. Long seam just inside the entry door and the short seam under the window came completely unstapled all the way down even along the floor. Pulled all the loose staples, removed the seam tape from under the window and the long seam tape for the ceiling just inside the entry door. Double checked all the staples to ensure that they were all pulled and recessed so that the panel would lay flat. Using a pneumatic, staple gun, staple the paneling on both seams along the floor and both studs under the window. With new seam tape, replaced the seam tape under the window and the long piece just inside the entry door. Used putty stick and puttied all visible, staple holes. Work is now complete. Requesting 1hr

matched • confidence 0.98

Old seal has to be removed, slot needs to be cleaned. New seal has to be cut for right size and installed in factory location. Seal needs to be adjusted as needed *73528* Photos attached Request .75 06.16.26: Pulled the whole seal out. Reattached the seal all the way around. The seal is rubber and clips into place on the window frame. Checked window and screen for proper operation window working properly Work completed Requesting .20

matched • confidence 0.88

Batten needs to be stapled and glued to the wall. It needs to be siliconed to the shower wall so it doesnt leak water behind of shower panned. Shower wall needs to be resealed on the wall that holds the shower in place. Photos attached *73528* Request .75 06.16.26: Trim on the shower edge on both sides had come loose and one side had fallen completely off. Found on the trim a total of four staples holding the trim in place on each side. Completely removed the staples from the trim that fell off. Used a brad nailer, nailed the trim back in place. On the other side remove the two staples that were visible. Used the brad nailer and nailed the trim back in place. Used putty stick sealing putting all new nail holes and old staple holes. The trim is now secure. Found 3 places on the shower surround that were loose, added rivets to secure the shower surround from bubbling. For a total of 4 rivets. Sealed the top and bottom of the shower surround with white silicone Work completed Requesting 1.5hrs

matched • confidence 0.86

Striker plate needs to be unscrewed and adjusted. Screwed back on adjusted for front door to make sure I don't damage front door. Photos attached .20 *60349* 06.16.26: Removed the round head screws, flattened out the striker plate. Used flat head screws, reattached the striker plate. Door is not sticking on the striker plate and closes properly. Work completed Requesting .20

matched • confidence 0.86

Photos attached *60349* Request 30 min Removed the cover from the battery and disconnected the battery. Tested the voltage on the battery battery indicated full charge. Tested the charging system, charging system putting out the correct voltage Could not smell any unusual loaders caps from both sides of the battery it smell a rotten egg go noticed on the positive side. All three cells were completely dried on the negative side. Two of the three cells were completely dry. Remove the battery from the couch tested it with the interstate battery tester did recommend replacement of the battery. Due to the dry cells in the battery is not covered by warranty contacted the customer customer stated to take care of himself Battery is put back in the box however it was not reconnected to the coach Job complete Request 45 minutes

matched • confidence 0.81

Wood support inside of compartment has to be screwed and stapled back into place. Supports have to be screwed from inside out to hold support also. Page 5 of 6 © 2026 Integrated Dealer Systems *73528* Photos attached Promised Date: 28 AUG 26 W/O: 73528 Request 1.0 Removed the rear support completely Measured and cut a new support that would cover the whole area corner to corner and attach an upright support and not just paneling Squared the shelf attached the support with screws to the corners Pre drilled hole in the side support and screwed the side support to the paneling Reattached the shelf with staples Reinstalled the drawer Work completed Requesting 1 hour

matched • confidence 0.74