iClaims Intelligence

Found the refrigerator was not in the cabinet square. the bottom was sticking out more than an inch further than top Found the refrigerator only has rollers on all four corners and the rear is not adjustable Removed the plastic grill from the front bottom and found the adjustment screws Lowered the front rollers until the refrigerator was much more plumb in the cabinet Also found the refrigerator was secured in the cabinet at all and was free to move in and out Found shop supplies metal angle shelf supports that fit at the front base that could be attached to the floor to prevent the refrigerator from rolling forward The angles were attached the refrigerator is now secure 1.25hrs INC., MYERS "RV" CENTER, Customer #: 1000 Labor Job # Description Total 7 REFER 179.00 Parts Part # Description Qty Price Total 18935 GE REFRIGERATOR WATER FILTER 1.00 64.97 64.97 Subtotal for Job #7: 243.97 Job #8 - Warranty

matched • confidence 0.95

During the sfd the outdoor kitchen door was open Extending the slide the door struck the building causing heavy damage to the door The door was removed straightened and squared so that it will open and close the damaged edge was sealed with silicone and additional rivets added inside to hold the door together Pictures attached to the sfd Door needs to be replaced along with the decals Job on hold for parts Labor Job # Description Total 5 COMPARTMENT DOOR N/C

matched • confidence 0.85

Found the water heater water lines were disconnected from the back of the water Found the refrigerator water filter was full of antifreeze Found the filter for the trauma aqua go was broken

matched • confidence 0.81

Reconnected the water lines to he back of the water heater Found the filter for the water heater in the battery compartment Installed the filter in the water heater Turned the pump on to fill the water heater Found water flowing out of the filter Turned pump off Found a stock unit with the same trauma system taken from 28551

matched • confidence 0.81

Found during the sfd the brake amps for the break away was 6.8 which is too low for tandem axle unit Followed the wiring into the 7 way junction box verified correct wiring which was correct Verified voltage in the junction box which was correct Got under the unit and checked amperage at the back of each hub Found the correct amperage to both rear hubs and no amperage at either hub on the front axle Inspected the wiring and found two issues First the connectors from the main wire to split to the brake hubs appeared to be damaged allowing to much play in the wires Second one of he wires from the connector to the drivers side front hub had been rubbing on the leaf spring and had been arcing on the metal Replaced the two connectors for the main wiring then cut and spliced the damaged wire Retested the amps at the break away and found the amps were now 12.2 which is within acceptable range Work completed 1.50hrs Page 3 of 5 © 2026 Integrated Dealer Systems *73133* Promised Date: 17 APR 26 W/O: 73133

matched • confidence 0.80

Found the stove oven had no power not allowing burners to light Tracked the wiring from behind the stove to the basement Opened the access panel in the basement for the control boards Located the wiring for the stove and found the power side was disconnected Using a volt meter found the connector for he stove Reconnected the wire *1000* Tested the stove and oven all components are now working .80HRS

matched • confidence 0.79