iClaims Intelligence

MYRV 12024 • Approved / Unpaid • prime-time

No evidence summary yet.

Path: /home/openclaw/nas/Dropbox/MYRV 12024/5- Pre-Authorizations Approved- MYRV/Prime Time/73090-2/Integrity Management Advisors Mail - RE_ 2798967 - line 4.pdf

Pulled the switch panel off of the wall tested for power and ground of the awning switch. I had 8 V at the switch and had a good ground. Tested the switch for proper function and it does function properly. Disconnected the switch leg to the awning which is yellow and white. Found the white wire has a short to ground. I pulled on the yellow and white wire that comes through the ceiling and I was able to free up about 6 inches and the short in the white wire went away. My guess it was just a staple and I pulled the staple out. There is no more short Im not going to run a new wire at this time however if this issue comes back I will have to run a new wire from the switch panel down to the awning. As far as the low-voltage goes the black and white wire runs across the bottom of the cabinet in the kitchen so we pulled the two lights tested for good connection to make sure there is no voltage drop through the lights didnt see any bad connections. The fuse panel has proper output voltage. We pulled the fuse panel to see where that wire runs and it runs behind the refrigerator. Had to pull the refrigerator to find out whats back there. I had a *1000* good voltage before the refrigerator and bad voltage behind the refrigerator. After removing the refrigerator we found a section of wire that had been stripped and some wires that had been kinked.So we cut out the defective area and reconnected with butt connectors. Tested for proper voltage at the switch panel voltage was correct. All the lights inside and the awning is working now as it should. Refrigerator it had to be reinstalled two lights had to be reinstalled switch panel I had to be reinstalled connections at the awning had to be remade and resealed. Job completed requesting 3 hrs and 45 mins for repair

matched • confidence 0.91

Style is damaged due to the door over closing and rubbing against the style during transport ,need to order and replace style and add rubber stops to prevent further damage to new style .In order to remove the right side style of the shelves I will need to remove all four shelves and the top and the bottom style to gain better access to remove the actual damaged piece of style.will need to remove all 4 shelves on the right side of the pantry. Removing the shelves will require me to remove the framing support for each shelf by removing the seven screws underneath of each shelf and then removing the staplesFor *1000* the style on the front of each side for shelves. Requesting 30 minutes per shelf. There is four shelves Once the shelves are removed I can then start to remove the side trim that is damaged that needs to be replaced.Will need to remove the multiple screws that are screwed city one by one support on the back of the style and that should remove it from the wall. Requesting 45 minutes to remove the right side damaged style . once all of the shelves in the top bottom and sides style or remove I can then cut a new style cut a new style to size and then install the reinstall the shelves individually one at a time once all of the shelves and the top and the bottom style are reinstalled I can then reinstall the right side damaged facia with a new piece and then staple up and secure in the place accordingly. Requesting 4 1/2 hours for removal Replacement and installation of new style. Style dimensions are 3in x 74 in

matched • confidence 0.71