iClaims Intelligence

MYRV 12024 • Paid • open-range

No evidence summary yet.

Path: /home/openclaw/nas/Dropbox/MYRV 12024/8- Claims Paid/April 2026/Open Range/72998/Paid claim.pdf

Checked the propane to insure there was propane in the bottles Lit the cook top burners lit and had proper flame Removed and tested the thermostat for proper operation is working properly In order to gain full access to the furnace for further testing I will have to remove the right dinette bench completely The water pump and tank fill line will have to be removed Duct work disconnected Disconnect the exhaust and cut silicone on the outside Disconnect electrical and unscrew furnace from the floor Remove the furnace and bench test for further diagnostic *60002* Request 3 hours for disassembly and re-assembly not including any diagnostic time or furnace repairs Removed dinette table Removed bench numerous screws from the floor and wall Disconnected the gas line Unscrewed the furnace from the floor Removed the exhaust tubes Disconnected air duct on the rear and dinette side Removed the furnace Bench tested the furnace Tested power to the sail switch and continuity was work correctly Tested the control board was working correctly Found the on/off switch inside the face that is to the out outer wall of the unit was off Turned the switch on tested the gas valve Hooked the furnace up to gas and power and ran furnace worked Took the furnace back into the unit Reconnected the furnace the electric gas and duct Reattached the exhaust Bubble tested the gas Turned the furnace on and it was working properly Finished the furnace install that it was completely installed and hooked up Reinstalled the bench and table Ran the furnace on and off two more times worked each time Work on the furnace is complete Page 1 of 2 © 2026 Integrated Dealer Systems *72998* 3.50HRS Promised Date: 13 MAR 26 W/O: 72998

matched • confidence 0.67